Raider RD-LGS01T Original Instruction Manual page 13

13
transportation.
8. Never attempt to place greater body than the size rendered in the machine's specifications. This
could seriously damage the machine.
9. Splitting should be in the direction of the fiber length of the wood.
10. Never put two logs at the same time.
11. The log should move to blade at an angle of 90 °.
12. Never place the log in already moving piston.
13. Keep your hands away from the movement of the piston.
14. Never leave the machine at chopping wood mode for more than 5 seconds. After this interval, the
oil pressure will will go beyond the norm and can seriously damage the machine.
15. Do not race the blade at the top.
16. Never leave the machine switched on and unattended.
17. The log splitting machine should not be used under the influence of alcohol, strong medicines.
18. Never ask for help in the removal of nested log.
19. Never use electric machines near gas, gasoline and other flammable liquids.
20. Before the machine set the voltage of electricity. Network. Make sure that there is grounding.
21. Do not open the cable box of the machine . This manipulation can be performed only by qualified
person.
Note. See. warranty terms
22. Make sure the machine and the power cable is not in contact with water.
23. Keep the power cord away from moving parts, machine oil and sharp objects.
24. Never leave the turned on machine unattended. In case of repair and adjustment of the machine,
unplug the power cable in advance.
Attention! Do not use a cable longer than 10 meters.
Attention! To prevent accidents, assemble all parts of the kit before you go over the working
with the machine. Remove all the screws and other parts that are helpful only for transportation.
1. Carefully move all parts of the box and put them in the place where the machine will operate. The
height of the workplace should not be less than 60 cm.
Divide the parts and check the list of them in the Instructions manual, so you can be sure everything
is in the set.
Attention! If any part is missing do not connect the machine until the missing part is been installed. Not
observing of this requirement, can cause serious damage to the machine. Warranty does not apply.
2. Do not throw out of the packaging machine until are sure in the integrity of the set.
Note: If any part is missing or damaged in transit, do not turn the machine to the power. Connect it
when the set is full.
3. ASSEMBLING
1. Before using the machine for splitting wood is necessary to put two wheels (2) on the axle (1). Place
the washer (3) and screw the nut (4) with a wrench. (See. Fig. Below).
2. Put the tray (4) to the machine frame, use two screws and washers.
3. Use the bolts from the kit to place the protective cover on the hydraulic control (4).
4. Place the rubber button on the hydraulic control (5).
Working with RD-LGS01T
Attention! Before starting work with the machine, the stopgap (13) must be released to allow rotation
and air to enter slightly into the oil tank.
When transporting the machine for chopping wood, you must make sure that the stopgap (13) is well
tightened and no oil is leaking.