Advertisement
TESTING THE DETECTOR
1. For testing purposes, use only the calibration gases. Never test the detector using cigarette smoke.
2. If the detector shows a different value of concentration than that of the calibration compound, re-calibrate the detector.
CAUTION: IF THE ALARM SOUNDS AND YOU ARE NOT PERFORMING THE TEST THIS REPRESENTS A REAL ALARM!! THIS ALARM
REQUIRES YOUR IMMEDIATE ATTENTION AND ACTION.
Compounds that may affect or damage the sensor and cause erroneous measurements include: methane, propane, isobutane,
isopropanol, ethyl acetate, alcohols, lacquers, paints, thinners, solvents, glues, hair spray, aftershave, perfume, and certain cleaning
materials. Avoid the contact of the detector with any of these substances.
MAINTENANCE
In the case of serious contamination disconnect the detector from the battery and clean the surface of the detector with a damp
cloth. To maintain the proper functioning of the detector it is also necessary to calibrate the instrument:
to carry out calibration at least once a year (i.e. setting the detection limits, checking the responsiveness of the sensor,
checking the functionality of the detector). The exact time interval depends on the purity of the environment, the level of accura-
cy required and the occurrence of selective gases in the environment.
Note: In the event of frequent use we recommend carrying out calibration at least once every six months.
Calibrate the device at an authorised service centre holding a valid certificate from the manufacturer or at the manufacturer's
premises!
GENERAL WARRANTY TERMS AND CONDITIONS
When following the instructions for installation, operation and maintenance, the manufacturer guarantee 24 months from
the date of receipt for the product. Should the product purchased be put into operation by an entity other than the seller, the
warranty period commences from the date that the product is put into operation, provided that the buyer ordered its commissioning
within three weeks of its receipt. The customer expressly acknowledges that during the warranty period that extends beyond the
length of the warranty period that is specified in the Commercial Code (the statutory warranty) s/he can neither require replacement
of the product nor may s/he withdraw from the contract.
1.
Claims concerning the product (for a warranty repair only complete devices are accepted) may be filed during the warranty
period only with the seller from which it was purchased; subsequently the seller is required to forward the product to an
authorised service centre or to the manufacturer.
This warranty is not applicable to:
2.
-
damage caused by fire, water, static electricity, power surges in the electric supply or in the public network, accident, improper
use of the product, wear and tear
-
contamination of the product and its subsequent cleaning,
damage caused by improper installation, any adjustment, modification or improper manner of use inconsistent with the
-
instruction manual, the technical standards or the applicable safety regulations in the Czech Republic,
-
damage to the product during transportation caused by improper handling or handling of the product in a manner contrary to
the advice provided in the instruction manual,
-
Detector (calibration) settings
DEGA products that have been used in association with other than original DEGA products, including consumables and
-
accessories,
-
bearing additional parts or consumables (e.g. a foil label, seal, etc.), that are detrimental to normal wear and tear during
operation, together with wear and tear of the product and its parts caused by their normal use.
5.
Claims regarding a product defect that can be dealt with reasonably quickly and without additional consequences will be
resolved by remedying the defect (repair) or by replacement of the product part , because in such a case it is a contradiction of
the standard norms that the entire product shall be replaced (§ 616, paragraph 4 of the Commercial Code).
6.
The buyer who exercises the right of warranty repair is not entitled to the return of the parts that have been replaced.
8.
For the complete version of the general business conditions and of the claims procedure go to www.dega.cz
Manufacturer: DEGA CZ s.r.o., K Žižkovu 640/9, 190 00 Prague 9, Czech Republic
Tax ID: CZ 279 029 43, Company ID: 279 02 943; Telephone (cz) : +420 774 447 660-5, Fax: +420 227 203 512
E-mail: info@dega.cz , Web: www.dega.cz
© 2012 DEGA CZ S.R.O.
USER MANUAL VER.: 04DEGAPBCII201210
PAGE 4
Advertisement
