Advertisement
Quick Links
INSTRUCTION
MANUAL
Portable Carbon Monoxide Detector
DEGA PBC-EL II
ISO 9001:2008
Quality Management Systems
Systéme de Qualité
www.sgs.com
Content
Page 2 / For your protection
Page 3 / Technical data and information
Page 3 / Description of the product
LCD display
Page 3 / Directions for use
Connecting the battery
Switching the device on and off
Turning the display backlight on and off
Setting the detection limit
Alarm activation
Page 3 / Caution
Page 3 / Basic information concerning carbon monoxide
Page 4 / Testing the detector
Page 4 / Maintenance
Page 4 / General warranty terms and conditions
Reproduction of this manual, or any part thereof, in any form, without the prior written permission of DEGA CZ s.r.o.
is prohibited.
DEGA CZ s.r.o. reserves the right to alter the specifications of the hardware and software described in this manual at
any time and without prior notice.
DEGA CZ s.r.o. bears no liable for any damage resulting from the use of this device!
FOR YOUR PROTECTION
In the event of an equipment failure immediately disconnect the item from the power supply
(i.e. remove the battery)
If you notice any unusual odour or smoke emanating from the product, remove the battery and allow the product
checked at an authorised service centre or by the manufacturer.
Do not use the device near flammable gases or in areas where there is the potential presence of such gases
Do not use electronic equipment in the presence of a flammable gas; this could cause a fire or an explosion. The
product is not designed for use in industrial or commercial spaces nor in „Ex" hazardous areas. For applications of this
nature, we recommend the use of DEGA M-Sx-yl II or P-Sx Multi II
Do not disassemble the product and ensure against its contact with water
Contact with internal components of the product may cause an electric shock. In the case of any failure refer the
servicing of the product exclusively to a certified service centre. Contact with water can create a short circuit in the
product and consequent damage to property or personal injury.
Advertisement
Related Manuals for DEGA PBC-EL II
Summary of Contents for DEGA PBC-EL II
- Page 1 Page 4 / Maintenance Page 4 / General warranty terms and conditions Reproduction of this manual, or any part thereof, in any form, without the prior written permission of DEGA CZ s.r.o. is prohibited. DEGA CZ s.r.o. reserves the right to alter the specifications of the hardware and software described in this manual at any time and without prior notice.
- Page 2 TECHNICAL DATA AND INFORMATION Supply voltage: 3 x AA batteries (1,5 V) preferably alkaline Battery life: about 100 hours with the backlight switched off Type of sensor: electrochemical Expected operational life of the sensor in a clean environment: 2 years (max. 3 years) Operating temperature range: max -10°C to +50°C Relative humidity of the ambient air:...
- Page 3 DIRECTIONS FOR USE CONNECTING THE BATTERY Pull on the back cover to remove it and insert 3 x 1.5 V AAA alkaline batteries. Pay attention that their polarity is correct. SWITCHING THE DEVICE ON AND OFF With charged batteries switch the device on by pressing and holding the „MODE ON“ button for 2 seconds. After it is switched on the device it will be in the measurement mode and the display will show „SCAN“.
- Page 4 Detector (calibration) settings DEGA products that have been used in association with other than original DEGA products, including consumables and accessories, bearing additional parts or consumables (e.g. a foil label, seal, etc.), that are detrimental to normal wear and tear during operation, together with wear and tear of the product and its parts caused by their normal use.