Advertisement
SAFETY PRECAUTIONS (FOR EUROPE)
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
This unit should be used with 12 V DC only.
CAUTION:
To prevent electric shocks and fire hazards, do
NOT use any other power source.
Note:
The rating plate (serial number plate) is on this unit.
CAUTION
To prevent electric shock, do not open the cabinet. No user
serviceable parts inside. Refer servicing to qualified service
personnel.
This equipment is in conformity with the provisions and protection requirements of the corre-
sponding European Directives. This equipment is designed for professional video appliances
and can be used in the following environments:
Residential (including both of the location type class 1 and 2 found in IEC 1000-2-5)
Commercial and light industrial (including, for example, theatres)
Urban outdoors (based on the definition of location type class 6 in IEC 1000-2-5)
This apparatus is designed for rack mounting or is used close to other apparatus.
In order to keep the best performance and furthermore for electromagnetic compatibility we
recommend to use cables not exceeding the following lengths:
Port
Cable
COMP/ VBS OUT
Shielded Twist Pair Cable
Caution:
Where there are strong electromagnetic waves or magnetism, for example near a radio or
TV transmitter, transformer, motor, etc., the picture may be disturbed.
In such a case, please keep the apparatus away from the sources of the disturbance.
4
Mounting this card to KY-F560 Camera
KY-F560
Slot cover
KY-F560
Length
less than 2 m
Slot
Analog output
terminal
Thank you for purchasing the KA-F5604U Analog output card.
By inserting this card into JVC's color video camera
KY-F560, either composite video signal, component
video signal(Y/Cb/Cr), RGB signal or Y/C signal is
output.
Analog output
terminal
KY-F560 power must be switched off before mounting
the card.
1.
Remove two screws Å from the rear of the camera and
take out the slot cover.
Screw Å
2.
Insert this Analog output card into the slot at the rear of
This card
the camera and secure it by screwing back the two
screws Å which were taken out earlier in the above
mentioned step
Notes
Ensure that the Analog output card is inserted
Screw Å
all the way in.
1
. .
5
Advertisement
