Trolley Stand - MIMSAL MS User Manual

3.1 TROLLEY STAND

REF
09651
Install the accessory without the lighting unit installed on it.
It is the customer's responsibility to ensure that the surface that it is attached to is
secure and sufficiently strong.
Check regularly that the unit is still stable in order to avoid the possibility of the
lighting unit falling down.
The rolling base is only designed to support the weight of the lighting unit. If additional
weight is added, the unit may tip over and cause damage to the lighting unit and/or
injury to the user.
1. Installation and assembly
- Insert piece (2) totally into the base (3) and press down.
- Insert the legs with the wheels (4) through the base slot (3) until it completely fits, and if
necessary helping with a nylon hammer.
- Fit piece 5 into the interior leg slots (4) by pressing down.
- Put the screw (7) through the washer (6) and insert the screw into piece 5 to connect the set.
- Join the pole (1) directly with the screw (7) without
tightening the pole (1) with the piece (2) so as not to
damage the paint.
- Hold the pole (1) firmly and turn the screw (7) with a
wrench or a scanner until the whole set is tight.
- Luminaries fixation system (8). Allen number 2.
2. Technical characteristics
- Length of pole:
- Total length:
- Base diameter:
- Wheel diameter:
- Number of wheels:
- Number of brakes:
MODEL
TROLLEY STAND 8,8 Kg
75 cm
92 cm
60 cm
50 mm
5
3
DESCRIPTION
8.8 Kg rolling base
Allen n. 2
1u. 8,8 Kg
ENG
8