Extension Arm - MIMSAL MS User Manual

3.5 EXTENSION ARM

REF
B0101S0 EXTENSION ARM
Install the accessory without the lighting unit installed on it.
It is the customer's responsibility to ensure that the surface that it is attached to is
secure and sufficiently strong.
Check regularly that the unit is still stable in order to avoid the possibility of the
lighting unit falling down.
The bracket is only designed to support the weight of the lamp. If additional weight is
added, this may cause damage to the lighting unit and/or injury to the user.
Installation and assembly
- Check that the wall is sufficiently hard-wearing and flat.
- Use the bracket to mark the holes on the wall with the help of a pencil (1).
- Drill holes and put the plugs into the wall (1).
- Position the wall support, lining it up with the location of the holes (2).
- Tighten the screws until the assembly, the guide separator and the screw are firmly attached
(2).
- Once the wall bracket is fixed and secure, position the end of the arm in the upper hole of the
support (3).
- Insert the shaft of the luminaire into the hole located at the other end of the extension arm (4).
- Turn the extension arm's side screw in order to secure the luminaire (5).
MODEL
Extension arm including Wall B Bracket. Provides an
additional 40 cm, with horizontal rotation along both axes.
DESCRIPTION
ENG
12