Toyota LEXUS LS430 2005 Manual page 301

AUDIO
CD player operation
(a) Inserting or ejecting CDs
The ignition switch must be in the "ACC" or "ON" position.
Your automatic changer can store up to 6 CDs.
20L150c
D Setting a single CD:
1. Push the "LOAD" button briefly.
The green indicators at both ends of the slot start blinking and
"WAIT" appears on the display. After the blinking indicators
stay on and the "WAIT" changes to the "LOAD", the CD door
opens.
2. Insert only one CD while the CD door is open.
You can set a CD at the lowest empty CD number.
After insertion, the set CD is automatically loaded.
If the label faces down, the CD cannot be played. In this case,
"ERROR1" and CD number appear on the display.
282
If you need to insert the next CD, repeat the same procedure
to insert another CD.
D Setting all the CDs:
1. Push the "LOAD" button until you hear a beep.
The green indicators at both ends of the slot start blinking and
"WAIT" appears on the display. After the blinking indicators
stay on and the "WAIT" changes to the "LOAD", the CD door
opens.
2. Insert only one CD while the CD door is open.
The CD door closes and "WAIT" appears again.
3. Insert the next CD after the "WAIT" changes to the
"LOAD" and the CD door opens.
4. Repeat this procedure until you insert all the CDs.
To cancel the operation, push the "LOAD" or "DISC" button.
If you do not insert the CDs within 15 seconds after pushing the
"LOAD" button and "LOAD" is displayed, the operation will be
canceled automatically.
NOTICE
Do not insert one CD stacked on top of another one or
feed them in continuously, to prevent CDs from getting
stuck in the player.