Toyota LEXUS LS430 2005 Manual page 143

INTERIOR EQUIPMENT
4. Repeat steps 1 through 3 for each remaining HomeLink
button to program another rolling code system.
Programming an entrance gate /
Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink
program.
2. Place your hand−held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
Keep the indicator light on the HomeLink
programming.
3. Press and hold the selected HomeLink
4. Continuously press and release (cycle) the hand−held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink
button to program another device.
124
R
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.
Reprogramming a button
R
buttons you want to
Individual HomeLink
reprogram a single button, follow the procedure "Programming
the HomeLink
R
.
(b) Operating the HomeLink
R
in view while
To operate the HomeLink
button to activate the programmed device. The HomeLink
R
button.
indicator light should come on. The HomeLink
send the signal for up to 20 seconds as long as the button is
pressed.
R
changes from a
R
by pressing the newly
R
R
buttons cannot be erased, however, to
R
".
R
R
, press the appropriate HomeLink
R
R
R
continues to