universalblue UBH2300-21 User Manual page 56

The furniture surfaces to be installed and the installation materials
to be used shall resist a temperature of at least 100 °C.
To prevent the appliance from turning over, the cabinet to be
installed shall be fixed and the cabinet floor shall be level.
The floor of the cabinet shall be strong enough to withstand a load
of at least 60 kg.
Placing and Securing Of The Oven
Place the oven to the cabinet with two or more persons.
Make sure that the frame of the oven and the front of the furniture
are properly aligned.
The supply cord shall not be left under the oven or be stuck or bent
between the oven and the furniture.
Secure the oven to the furniture using the screws supplied with the
appliance. Screws shall be installed by putting them through the
plastics attached on the frame of the appliance as shown in figure
5. The screws shall not be tightened too much. Otherwise, the screw
holes may wear out.
Check that the oven does not move after installation. If the oven has
not been installed in accordance with the installation instructions,
there is a risk of overturning during operation.
Electrical connection
The place where the product shall be installed shall have proper
electrical installation.
The mains voltage shall comply with the rating given on the product
type plate.
Connection of appliance shall be made in accordance with local and
national electrical regulations.
Disconnect the mains power before starting to install the product.
Do not connect the product to the mains until the installation is
finished
56