universalblue UBH2300-21 User Manual page 50

• Do not use cut or damaged cords or extension cords
other than the original cord.
• Make sure that there is no liquid or humidity in the
outlet where the product plug is installed.
• The rear surface of the oven also heats up when the
oven is operated. Electrical connections shall not touch
the rear surface, otherwise the connections may be
damaged.
• Do not tighten the connecting cables to the oven door
and do not run them over hot surfaces. If the cord
melts, this may cause the oven to short circuit and even
a fire.
• Unplug the unit during installation, maintenance,
cleaning and repair.
• If the power supply cable is damaged, it must be
replaced by its manufacturer or authorized technical
service or any other personnel qualified at the same
level, in order to avoid any dangerous situation.
• Make sure the plug is inserted firmly into wall socket to
avoid sparks.
• Do not use steam cleaners for cleaning the appliance,
otherwise electric shock may occur.
• An omnipolar switch capable to disconnect power
supply is required for installation. Disconnection from
power supply shall be provided with a switch or an
integrated fuse installed on fixed power supply
according to building code.
• Appliance is equipped with a type ''Y'' cord cable.
• Fixed connections shall be connected to a power
supply
appliances with over voltage category below III,
enabling omnipolar disconnection. For
50