TDK-Lambda CN-A110 Series Instruction Manual

BEFORE USING THE POWER SUPPLY UNIT
Be sure to read this instruction manual thoroughly before using this product. Pay attention to all cautions and warnings before using this product. Incorrect
usage could lead to an electrical shock, damage to the unit or a fire hazard.
DANGER
· Never use this product in locations where flammable gas or ignitable substances are present.
WARNING
· Do not touch this product or its internal components while it is in operation, or within 5 seconds of shut down. There may be high voltage or high temperature
present and you may receive an electric shock or burn.
· When the product is operating, keep your hands and face away from it as you may be injured by flying debris in the event of a fault.
· Do not make unauthorized changes to this product, otherwise you may receive an electric shock and void your warranty.
· Do not use this product in the event of the emission of smoke or abnormal smell and sound etc. It might lead to fire and/or electric shock. In such cases, please
contact us. Do not attempt repair by yourself, as it is dangerous for the user.
· Do not operate these products in the presence of condensation. It might lead to fire and/or electric shock.
· Do not drop or insert anything into the product. It might lead to a failure, fire and/or electric shock.
CAUTION
· This power supply is designed for use within an end product such that it is accessible to SERVICE ENGINEERS only.
· Confirm connections to input/output terminals and signal terminals are correct as indicated in the instruction manual before switching on.
· Input voltage, Output current, Output power, ambient temperature and ambient humidity should be kept within specifications, otherwise the product will be
damaged.
· Do not operate and store this product in an environment where condensation might occur. In such case, waterproof treatment is necessary.
· Do not use this product in environment with a strong electromagnetic field, corrosive gas or conductive substances.
· For applications which require very high reliability (Nuclear related equipment, traffic control equipment, etc.), it is necessary to provide a fail safe
mechanism in the end equipment.
· The information in this document is subject to change without prior notice. Please refer to the latest version of the data sheet, etc., for the most up-to date
specifications of the product.
· No part of this document may be copied or reproduced in any form without prior written consent of TDK-Lambda.
· Do not inject abnormal voltages into the output or signal of this product. The injection of reverse voltage or over voltage exceeding nominal output voltage
into the output or signal terminals might cause damage to internal components.
· Operation of this product under over-current or short circuit conditions can result in damage. Failures of the product under these conditions have been
assessed and are considered to be safe within the meaning of IEC/EN/UL/CSA 60950-1.
· This product contains a printed circuit board utilizing surface mounted devices. PCB stress such as bending, twisting etc could cause damage. Therefore,
please handle with care.
· In order to maintain SELV output, the baseplate must be protectively earthed in the end application. Where the baseplate is not earthed, the output must be
considered hazardous and must not be made user accessible"
· The output of this product may, under fault conditions, exceed SELV voltage limits. Therefore the output must be earthed in the end equipment to maintain
SELV. If the output is not earthed, they must be considered hazardous and must not be made user accessible.
· These products have been assessed for use with non-isolated mains derived DC where the mains source is up to 115VAC. For mains derived DC above this
source voltage, there must be isolation equivalent to reinforced insulation at the rated mains source voltage.
· The application circuits and their parameters are for reference only. Be sure to verify effectiveness of these circuits and their parameters before finalizing the
circuit design.
·
Use an HBC external fuse to each module to ensure safe operation and compliance with the Safety Standards to which it is approved.
Note : CE MARKING
CE Marking, when applied to a product covered by this handbook, indicates compliance with the low voltage directive.
CN-A110 SERIES
Instruction Manual
TDK-Lambda
CN-A110 Series
Instruction Manual
C256-04-11G