Warnings And Cautions - Honeywell PRO-2200 Installation Manual

4

Warnings and Cautions

WARNING
Before installation, TURN OFF the external circuit breaker which supplies power to the
system.
Before connecting the device to the power supply, verify that the output voltage is within
specifications of the power supply.
Do not apply power to the system until after the installation has been completed.
Personal injury or death could occur, and the equipment could be damaged beyond
repair, if these WARNINGS are not observed!
WARNING
Fire Safety and Liability Notice
Never connect card readers to any critical entry, exit door, barrier, elevator or gate
without providing an alternative exit in accordance with all fire and life safety codes
pertinent to the installation. These fire and safety codes vary from city to city and you
must get approval from local fire officials whenever using an electronic product to control
a door or other barrier. Use of egress buttons, for example, may be illegal in some cities.
In most applications, single action exit without prior knowledge of what to do is a life
safety requirement. Always make certain that any required approvals are obtained in
writing. DO NOT ACCEPT VERBAL APPROVALS, THEY ARE NOT VALID.
Engineered Systems never recommends using the PRO-2200 or related products as a
primary warning or monitoring system. Primary warning or monitoring systems should
always meet local fire and safety code requirements. The installer must also test the
system on a regular basis by instructing the end user in appropriate daily testing proce-
dures. Failure to test a system regularly could make installer liable for damages to the end
user if a problem occurs.
WARNING
EARTH ground all enclosures, for proper installation.
WARNING
Use suppressors on all door strikes. Use S-4 suppressors for installation. Engineering
Systems recommends only DC strikes.
The information in this document is subject to change without notice.
Installation Guide
PRO-2200 Output Module PRO22OUT