Initial Start-Up - MULTIQUIP Mikasa Series Operation And Parts Manual

CAUTION
DO NOT attempt to operate the
equipment until the Safety, General
Information and Inspection sections of
this manual have been read and
thoroughly understood .
This section is intended to assist the operator with the initial
start-up of the equipment. It is extremely important that this
section be read carefully before attempting to use the equipment
in the field.
Starting the Engine
1. Place the engine fuel valve lever (Figure 11) to the "ON"
position.
Figure 11. Engine Fuel Valve Lever (ON Position)
2. Move the throttle lever (Figure 12) away from the slow
position, about 1/3 of the way toward the fast position.
Figure 12. Throttle Lever (1/3 Start Position)
PAGE 18 — MVC-64E/EW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (05/11/06)
l
MVC-64E/EW — INITIAL START-UP
3. Place the choke lever (Figure 13) in the " CLOSED " position
if starting a cold engine.
Figure 13. Engine Choke Lever (Closed)
4. Place the choke lever (Figure 14) in the " OPEN " position
if starting a warm engine or the temperature is warm.
Figure 14. Engine Choke Lever (Open)
5. Place the engine ON/OFF switch (Figure 15) in the " ON "
position.
Figure 15. Engine ON/OFF Switch (ON Position)