Philio PAN45 Manual

Smart Energy Plug
This plug-in ON/OFF switch PAN45 is a devices displaying the Z-Wave Plus
also be used security enabled wireless switch, based on Z-Wave Plus technology. Z-
Wave Plus TM enabled with it regardless of the manufacturer, and can also be used in
other manufacturer's Z-Wave TM enabled networks. Remote On/Off control of the con-
nected load is possible with another manufacturer's wireless Controller. Each switch is
designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure that the
signal is received by its intended destination by routing the signal around obstacles and
radio dead spots. Because PAN45 supports Security Command Class, it can learn with
Secured controller. Its functionality and supported command classes are identical when
included as a secure and non-secure device. It also have Zigbee as a repeater.
This plug-in ON/OFF switch is able to detect instance wattage (3000W/230Vac/13A)
and overload current (14.5A with resistive load) of connected lights or appliances. When
detecting overload state, the Switch will be disabled and it's On/Off button will be lock-
out of which LED will flash quickly. However, unplug and reconnect the switch will re-
set its overload condition to normal status.
PAN45
Specification
Operating Voltage
Maximum Load (Ampere)
Range
Operating Temperature
Location
Frequency Range
RF Maximum Power
TM logo can
** Specifications are subject to change and improvement without notice.
Troubleshooting
Symptom
The Switch not working
and LED off
The Switch LED illumi-
nating, but cannot control
the Switch of the load at-
tached
The Switch LED illumi-
nating, but the Detector
cannot control the Switch
LED keep flashing, but
cannot control
100V-240V~ 50Hz-60Hz
13A (Resistive load)
Minimum 40 m in door 100m outdoor line of sight
0°C ~ 40°C, 85%RH max
In door use
Z-Wave: 868.40MHz & 869.85MHz (EU)
Zigbee: 2405-2480MHz
+10dBm (Peak), -10dBm (Average) for Z-wave
+10dBm for Zigbee
Cause of Failure
1.The Switch is not plugged into 1. Check power connections
the electrical outlet properly 2. Don't open up the Switch
2.The Switch break down and send it for repair.
1. Set the ON/OFF switch of
1.Check if the load plugged into
the load attached to ON
the Switch has its own ON/OFF
2. Unprotected the switch or
switch
follow the instruction of pro-
2. The switch is protected
tection.
1. Not carry out association 1. Carry out association
2. Same frequency interference 2. Wait for a while to retry
Remove the load attached or
Overload occurs check max. load cannot ex-
ceed 13A (Resistive load)
Recommendation