Advertisement
Receiver Controls and Functions
Front Panel Controls and Functions
1. Antenna: Detachable UHF antenna with BNC connector.
2. Power Button: Press and hold to power on/off.
3. RF Red LED: Displays the reception status of RF signal.
4. Channel ID Display
5. AF Red LED: Displays the reception status of AF signal.
1
Rear Panel Controls and Functions
1. Antenna BNC Receptacle: This provides a connection to the supplied
antennas or to coaxial cable used with an antenna divider, antenna
booster or remote antennas.
2. Balanced XLR Audio Output Jack
3. Unbalanced ¼" Output Jack
4. Mic/Line Switch: Use this to adjust the audio output of the wireless
microphone system for mic level (-20 dB) or line-level (0 dB).
3
4
RF
ATW-R1
2
3
2
ANT B
AUDIO OUT
BALANCED
UNBALANCED
1
3
6. UP Channel Button: Press and hold until the channel ID number begins to
blink. Then tap the button to select a new channel (+1 ch/tap). Release the
button. When the channel ID number stops blinking, the new channel is set.
7. DOWN Channel Button: Press and hold until the channel ID number
begins to blink. Then tap the button to select a new channel (-1 ch/tap).
Release the button. When the channel ID number stops blinking, the new
channel is set.
6
UP
AF
DOWN
5
7
5. SQ (Squelch): Turn the squelch to the lowest possible setting (counter-
clockwise) to maximize the range of the system. In RF-crowded
environments (other wireless microphones, LTE, etc.) it may be necessary
to increase the squelch level (clockwise) to block out unwanted RF
interference. Please note that this will reduce the operating distance of
the system, so always seek the lowest possible setting.
6. DC IN: DC input connector for the supplied AC adapter.
7. Cable Strain
7
ANT A
SQ
DC 12V 500mA
LINE MIC
4
5
6
1
Advertisement
