Advertisement
Receiver Controls and Functions
1a
Figure A — Front Panel Controls and Functions
1. ANTENNAS: Position the "signal" antenna (1a) and
"ground" antenna (1b) as shown to the right and above right. Fully
extend both antennas by pulling on the endcaps.
2. RF INDICATOR: Lights to show presence of transmitter signal.
3. POWER INDICATOR: Lights when power is supplied to
the receiver.
4. AF PEAK INDICATOR: Only lights when audio distortion
is present at maximum modulation. Not affected by
position of Volume control.
Figure B — Rear Panel Controls and Functions
1. SQUELCH CONTROL: Adjusts level of noise-muting circuit
(preset at factory but can be adjusted as circumstances warrant).
2. VOLUME CONTROL: Adjusts the audio level at the
output jack. Does not affect AF Peak indicator.
3. AUDIO OUTPUT JACK:
/
" TS (Tip-Sleeve) or "mono"
1
4
phone jack. Use a shielded cable to connect to an
unbalanced aux-level input of a mixer or amplifier.
4. POWER INPUT JACK: Connect the DC plug from the
included AC adapter.
5. CORD HOOK: Loop the cord around the cord hook to keep
the DC plug from pulling out accidentally.
3
2
4
POWER
SYSTEM
8
RF
PEAK
1
2
3
MIN.
MAX.
MIN.
MAX.
SQUELCH
VOLUME
UNBALANCED
/
"
1
4
System 8 Installation and Operation
1b
POWER
RF
PEAK
4
5
DC 12V IN
500mA
3
POWER
SYSTEM
8
RF
PEAK
SYSTEM
8
Advertisement
