Front Door Opening - ICI Caldaie REX F 7 Instructions For Installation, Use And Maintenance Manual

FRONT DOOR OPENING

The door is adjusted in the factory with standard opening to the left (Sx) and hinges on the right (Dx).
DANGER
a
It is DANGEROUS TO UNSCREW the ferrules (8) on the side of the hinges. This may cause the door to detach, with
possible serious harm to people and property damage.
DOOR OPENING REVERSAL (TO THE RIGHT)
NOTE
The ferrules (8) can be "adjusted with wrench" or "perforated for lever adjustment".
DOOR WITH FERRULES PERFORATED ON BOTH SIDES
Proceed as follows to reverse the opening direction of the door:
– screw the left perforated ferrules (1) so that the door seal gasket is pressed in the same way as the right part. Bring the conical
washers (2) of the left tie-rods close to the mechanical tubes (3) of the door and tighten the nuts (4) using a suitable wrench
– on the right opening side, loosen the nuts (5) and free the conical washers (6) from the mechanical tubes (7) of the door.
DOOR WITH WRENCH FERRULES, HINGE SIDE
DANGER
a
In models equipped with wrench-adjustable ferrules (8), these must always be mounted on the hinges to prevent the
door from being accidentally opened through the lever (9).
Proceed as follows to reverse the opening direction of the door:
– screw the left perforated ferrules (1) so that the door seal gasket is pressed in the same way as the right part. Bring the conical
washers (2) of the left tie-rods close to the mechanical tubes (3) of the door and tighten the nuts (4) using a suitable wrench
– cross-change the wrench ferrule of a hinge (8) with the opposite perforated ferrule (1), after loosening the locking nuts on the
tie rods and freeing the conical washers
– on the left hinge side, fasten the conical washer (2) onto the door using the nut (4s)
– repeat the last two steps for the other two ferrules also.
DANGER
a
When cross-changing ferrules, always make sure that the other two ferrules are fastened, so that they hold the door.
Check the correct adjustment of the tie-rods and hinges ensuring that, during closure, the seal gasket is evenly pressed in the
centre on the whole circumference. If necessary, adjust the door as described in the following paragraph.
Installation
Cooke Industries - Phone: +64 9 579 2185 Email: sales@cookeindustries.co.nz Web: www.cookeindustries.co.nz
Sx
9
3 2
1
4
Dx
7 6
8 5
15