Table of Contents
Advertisement
Reinforcing the bass—BASS BOOST
You can boost the bass level—Bass Boost.
• Once you have made an adjustment, it is memorized for
each source.
• You cannot adjust directly from the remote control.
B BOOST ON
Select to boost the bass level.
The B.BOOST indicator lights up on the
display.
B BOOST OFF
Select to deactivate the Bass Boost.
Initial setting:
OFF
NOTE
This function affects only the sound coming out through the front
speakers.
Attenuating the input signal—
INPUT ATT
When the input level of analog source is too high, the sound
will be distorted. If this happens, you need to attenuate the
input signal level to prevent the sound distortion.
• Once you have made an adjustment, it is memorized for
each source.
• You cannot adjust directly from the remote control.
ATT ON
Select to attenuate the input signal level.
The INPUT ATT indicator lights up on the
display.
ATT NORMAL
Select to deactivate attenuation.
Initial setting:
NORMAL
Adjusting the sound parameters for
the Surround/DSP modes
You can adjust the Surround/DSP sound parameters to your
preference.
• For details about the Surround/DSP modes, see pages 39 to
44.
• You cannot adjust these items directly from the remote
control.
7 Adjusting the effect level for DSP modes—
EFFECT
This setting is available only when one of the DSP modes
(except All Channel Stereo) is in use. To activate DSP mode,
see pages 43 and 44.
• Once you have made an adjustment, it is memorized for
each DSP mode.
Adjustable range: 1 to 5 (in 1 step intervals)
Initial setting:
3
As the number increases, the effect becomes stronger.
Normally, select "3."
7 Adjusting the virtual room size for DSP
modes—ROOM SIZE
This setting is available only when one of the DSP modes
(except All Channel Stereo) is in use. To activate DSP mode,
see pages 43 and 44.
• If "SURROUND SPK" is set to "NO" (see page 30), this item is
not adjustable.
• Once you have made an adjustment, it is memorized for
each DSP mode.
Adjustable range: 1 to 5 (in 1 step intervals)
Initial setting:
3
As the number increases, the interval between reflections
increases so that you will feel as if you were in a larger room.
Normally, select "3."
7 Adjusting the liveness effect for DSP
modes—LIVENESS
This setting is available only when one of the DSP modes
(except All Channel Stereo) is in use. To activate DSP mode,
see pages 43 and 44.
• If "SURROUND SPK" is set to "NO" (see page 30), this item is
not adjustable.
• Once you have made an adjustment, it is memorized for
each DSP mode.
Adjustable range: 1 to 5 (in 1 step intervals)
Initial setting:
3
As the number increases, the attenuation level of reflections
over time decreases so that acoustics change from "Dead" to
"Live."
Normally, select "3."
7 Adjusting the panorama control for Pro Logic
IIx Music and Pro Logic II Music—PANORAMA
This setting is available when Pro Logic IIx Music or Pro Logic
II Music is activated for the analog or digital 2-channel sound
signal.
To activate Pro Logic IIx Music or Pro Logic II Music, see pages
43 and 44.
• Once you have made an adjustment, it is memorized until
you change the setting.
PANORAMA ON
Select to add "wraparound" sound effect
with side-wall image.
PANORAMA OFF
Select to listen to originally recorded
sound.
Initial setting:
OFF
37
Advertisement
Chapters
Table of Contents
Troubleshooting
