JVC RX-D411SB Instructions Manual page 106

7 Selecting the Surround/DSP modes
From the remote control:
1
Select and play any source.
• Surround/DSP modes are not available when multi-
channel PCM (see page 41) signals recorded in DVD-
Audio are coming in. See page 11 for details.
• Make sure you have selected the audio input setting
(analog or digital) correctly (see page 21).
2
Press SURROUND repeatedly to select
the Surround/DSP mode you want.
Ex.: When "DOLBY DIGITAL" is selected for Dolby Digital
multi-channel software:
= Surround modes*
1
AUTO SURROUND*
= HALL2 = LIVE CLUB = DANCE CLUB = PAVILION
= THEATER1 = THEATER2 = MONO FILM*
= SURROUND OFF =
4
ALL CH STEREO*
(Back to the beginning)
* 1 "AUTO SURROUND" is the initial setting.
2
* Available Surround modes vary depending on the
speaker settings and the incoming signals. For details,
see page 42.
* 3 If an incoming signal is a multi-channel (more than 2
channel) digital signal, "MONO FILM" is not available.
* 4 If "SURROUND SPK" is set to "NO," "ALL CH STEREO" is
not available.
To cancel Surround/DSP modes
Press SURROUND repeatedly so that "SURROUND OFF"
appears on the display.
44
On the front panel:
1
Before you start, remember...
There is a time limit in doing the following steps. If the setting
is canceled before you finish, start from step
1
2
2
3
= HALL1
2
=
3
To cancel Surround/DSP modes
Turn MULTI JOG so that "SURROUND OFF" appears on the
display.
2
Select and play any source.
• Surround/DSP modes are not available when multi-
channel PCM (see page 41) signals recorded in DVD-
Audio are coming. See page 11 for details.
• Make sure you have selected the audio input setting
(analog or digital) correctly (see page 21).
Press SURROUND.
MULTI JOG now works for selecting Surround/DSP modes.
Turn MULTI JOG to select the Surround/
DSP mode you want.
Ex.: When "DOLBY DIGITAL" is selected for Dolby Digital
multi-channel software:
Ô Surround modes*
1
AUTO SURROUND*
Ô HALL2 Ô LIVE CLUB Ô DANCE CLUB Ô
PAVILION Ô THEATER1 Ô THEATER2 Ô MONO
Ô ALL CH STEREO* Ô SURROUND OFF Ô
3 4
FILM*
(Back to the beginning)
* 1 "AUTO SURROUND" is the initial setting.
2
* Available Surround modes vary depending on the
speaker settings and the incoming signals. For details,
see page 42.
* 3 If an incoming signal is a multi-channel (more than 2
channels) digital signal, "MONO FILM" is not available.
4
* If "SURROUND SPK" is set to "NO," "ALL CH STEREO" is
not available.
1, 3
2
again.
Ô HALL1
2