JVC RX-D411SB Instructions Manual page 13

Do not connect the AC power cord until all other connections have been made.
Connecting a DVD recorder or DVD player with its analog discrete output jacks (DVD MULTI IN):
If your DVD recorder or DVD player has analog 5.1 channel output jacks, use the connection below. When a DVD-Audio disc is
played back, the original high-quality multi-channel sounds can be reproduced by using this connection.
Turn off all components before making connections.
• When you connect the components, refer also to their manuals.
Å To left/right surround channel audio output
ı To center channel audio output
Ç To component video output
• Connect Y, P , and P correctly.
B R
Î To subwoofer output
‰ To left/right front channel audio output
When you enjoy the sound recorded in DVD-Audio...
You can enjoy the sound recorded in DVD-Audio with either
analog or digital methods.
– With analog method:
1. Connect your DVD recorder or DVD player to this
receiver according to the diagram above.
2. Select "A MULTI" for the audio input setting. (See page
21.)
– With digital method:
1. Connect your DVD recorder or DVD player and TV to this
receiver with the HDMI cables. (See page 9.)
2. Select "HDMI" for the audio input setting. (See page 21.)
Green
Blue
Red
Monaural audio cable (not supplied)
White
Red
Red
White
S-video cable (not supplied)
Composite video cable (not supplied)
Component video cable (not supplied)
White Stereo audio cable
(not supplied)
Red
Monaural audio cable
(not supplied)
Stereo audio cable
(not supplied)
Composite video cable
(not supplied)
Ï Only for DVD recorder: To left/right front channel audio
input
Ì To composite video output
Ó To S-video output
È Only for DVD recorder: To S-video input
Ô Only for DVD recorder: To composite video input
NOTES
• When selecting "A MULTI" for the audio input setting and using
the headphones, you can listen to the front channel sounds (left
and right) only. The 3D HEADPHONE mode (see page 42) is not
available.
• When selecting "A MULTI" for the audio input setting or when
multi-channel PCM signals (see page 41) are coming in with
selecting "HDMI" for the audio input setting, the following items
are not available:
– Precise Surround Setup (see pages 16 to 19)
– Decode mode (see page 22)
– CC Converter (see page 23)
– EX/ES/PLllx (see page 32)
– Dual Mono (see page 32)
– Subwoofer output (see page 33)
– Crossover frequency (see page 33)
– Low frequency effect attenuator (see page 33)
– Midnight mode (see page 33)
– Digital equalization patterns (see page 36)
– Bass Boost (see page 37)
– Input attenuator mode (see page 37)
– Sound parameters for Surround/DSP modes (see pages 37 and
38)
– Surround/DSP mode selection (see page 44)
• The audio delay level setting (see page 34) does not take effect
when selecting "A MULTI" for the audio input setting.
• When you enjoy the sound recorded in DVD-Audio through the
HDMI connection, use a DVD recorder or DVD player compatible
with HDMI version 1.1.
: signal flow
DVD recorder or
DVD player
11