Connecting The Speakers - JVC RX-D411SB Instructions Manual

Connecting the speakers

Do not connect the AC power cord until all other connections have been made.
7 Speaker Layout Diagram
FL C FR
SL
SBL (SB*) SBR
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by
the speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
7 Connecting the speakers
Turn off all components before making connections.
To connect the center speaker and the front speakers
1 2
1
Cut, twist and remove the insulation at
the end of each speaker cord.
2
Turn the knob counterclockwise.
3
Insert the speaker cord.
• For each speaker, connect the (+) and (–) terminals on
the rear panel to the (+) and (–) terminals marked on the
speakers.
4
Turn the knob clockwise.
8
Powered
subwoofer (SW)
SW
Left surround back
speaker (SBL)*
Right surround
back speaker (SBR)
SR
Right surround speaker (SR)
Left surround speaker (SL)
3 4
Center speaker (C)
To connect the surround speakers and the surround back
speakers
1 2
1
Cut, twist and remove the insulation at
the end of each speaker cord.
2
Open the terminal (1), then insert the
speaker cord (2).
• For each speaker, connect the (+) and (–) terminals on
the rear panel to the (+) and (–) terminals marked on the
speakers.
3
Close the terminal.
* When using a single speaker for the surround back
speaker
You can enjoy the surround sound by one surround back
speaker. When using one surround back speaker,
– set "S BACK OUT" to "1SPK" (see page 31) and
– connect the surround back speaker to the left surround
back speaker terminal. (No sound comes from the
speaker if you connect it to the right surround back
speaker terminal.)
7 Connecting the powered subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord with
RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or subwoofer, perform
Precise Surround Setup to adjust the speaker settings
automatically (see pages 16 to 19).
NOTE
You can place a subwoofer wherever you like since bass sound is non-
directional. Normally place it in front of you.
Right front
Left front
speaker (R)
speaker
(L)
3