Advertisement
2 1/8"
Self Drilling Screw
or Nail Location
Crossover Wire K Series
VOID in CB Series
_________________________________________________________________________________________
For
CB Ceramic Element Baseboard Heater
The CB Series baseboard heat er has t he ret urn wire wit hin
t he element and t he wireway is empt y. If your power supply is
on t he right side you will need t o cut t he loop t o apply your
power. If t he power supply is on t he lef t , cut one connect or
t o apply power supply similar t o diagram in Figure 5.
__________________________________________________________________________________________
For
K Series Element Baseboard Heater
Cut t o Apply Power t o
LEFT SIDE
Power Supply Connect ion
LEFT SIDE
___________________________________________________________________________________________
SUPPLY WIRES
HEATER WIRES
Connect ion Diagram f or Wall Mount ed Single Pole Thermost at
1. Red t hermost at wire t o black power supply wire.
2. Black t hermost at wire t o black heat er wire.
3. Whit e power supply wire t o whit e heat er wire.
4. Connect all bare groundwires t oget her.
Screwdriver Bit
or Nailing Tool
Location
Air Guide
Limit
Element
Figure 4
Cut t o Apply Power t o
RIGHT SIDE
Figure 5
Power Supply Connect ion
RIGHT SIDE
6. Follow t he desired wiring diagram, as shown in Figure 5, t o
connect t he power supply t o t he heat er using approved wire
nut s.
NOTE : When accessories are inst alled, use wiring diagram sup-
plied wit h t he accessory.
7. If f ront cover was removed, reinst all by hooking t he t op edge
on t he support bracket (s). Then push down t o lat ch ont o t he
support bracket (s).
8. Replace wiring compart ment cover(s).
9. Follow inst ruct ions accompanying t hermost at f or inst allat ion
and wiring t hermost at . Visit www. king-elect ric. com f or t ypical
t hermost at wiring diagrams.
Models
Models
Inst ruct ions f or Lef t or Right Side Wiring
1.
Heat er can be wired f rom eit her side - wire
one side only.
2.
Cut one f act ory splice cap as shown.
3.
This leaves t wo wires f or power connect ion.
4.
Caut ion:
on lef t side - you need only t wo wires f or
power connect ion.
Connect ion Diagram f or Wall Thermost at
1.
Connect power supply wires f rom wall t hermo-
st at as shown.
2.
Black and whit e supply wires can be connect ed
3.
t o t he heat er in reverse order. For simplicit y
t he
4.
most common met hod is shown.
5.
Connect bare groundwire t o green groundwire.
WIRE COLOR CHART
BLACK WIRE
RED WIRE
BARE GROUNDWIRE
WHITE WIRE
Connect ion Diagram f or Wall Mount ed Double Pole Thermost at
1.
Connect t he t wo red t hermost at wires t o t he black and
whit e power supply wires.
2.
Connect t he t wo black t hermost at wires t o t he black and
Whit e heat er wires.
3.
Connect all t he bare groundwires t oget her.
Figure 5
Do not cut bot h f act ory splice caps
SUPPLY WIRES
HEATER WIRES
Advertisement
