KING KBP2406 Installaltion & Maintenance Manual

INSTALLALTION & MAINTENANCE MANUAL
Model:
Unpack & Inspect Your New Heater
Remove the heater from the box and inspect it for any damage.
Verify that you have received the mounting bracket and
accesories.

Tools Needed

You will need the following tools to install your unit heater:
Screwdriver - (Phillips & Slotted), Wire Cutters, Pliers, Adjustable
Wrench, Electric Drill
Hardware Needed
You will need the following hardware:
-Adequate gauge & length of wire for your application
-Proper size fuses or breakers to handle amperage
-Proper wire connectors for your application
-Fasteners appropriate size to mount herater.
In certain applications, conduit may be required by code. Check
local electrical codes. If you want to be able to turn the heater,
be sure to use flexible conduit.
Mounting Height
When the air flow of the heater is directed vertically or horizontally,
the minimum mounting height is 6 feet in USA and 8 feet in Canada.
Mounting heights depend upon building utilization and heater KW
capacity.
Distance From Walls
Maintain 6" minimum clearance to side walls and 2" to ceiling in
back of the heater (Air Intake Side). Maintain 18" clearance in
front of the heater (Dischage Side.)
electrical mfg. company
9131 - 10th Avenue South Seattle Washington 98108
KBP2406
240V-1phase Unit Heater
WARNING
Model: KBP2406 is 240 volt. It is important that you
verify the power supply voltage is the same as the
nameplate voltage of the heater. Improper installation
or failure to follow the procedures as outlined in this
manual can result in damage to the heater. Note that
the KBP2406 will operate at 208 volt but will produce
25% less wattage and draw 13% less amps.
connect all power from the heater at the main service
panel before attempting to install or service this unit.
All electrical wiring must conform to local electrical
codes. Heater circuit must be properly protected.
Mounting Heater
Locate a stud in ceiling or wall and securely fasten bracket with a
minimum of two #12 fasteners 1-1/4" long. Attach heater to bracket
with 3/8" x 1" wing nut & lock washer supplied. Install the lock
washer between the bracket and heater, do not put lock washer
on the plastic wing nut. After desired air discharge position has
been determined, tighten wing nut so that heater will not pivot.
Location of Heater
The heater should be installed out of the reach of persons. The
direction of air flow should not be restricted by machinery, beams,
etc., and the air flow should wipe exposed walls, rather than
blowing directly at them. When more than one heater is used in an
area, the heaters should be arranged so that the air discharge of
each heater supports the air flow of the others to provide best
circulation of warm air. (See Air Flow Chart)
Dis-
kbp2406.pm65 rev 02/03