Heat Run Mode - Denon RCD-N7 Service Manual

5.2. Heat run Short mode
Playing last track on disc. After disc playback has finished, then tray open and close. And playback again.
The heat run repetition no. is incremented (increased by 1) when the tray is opened.
Repeat this operation.
[H.R. Short] displayed.
Select "H.R.Short", and press 1 / 3 ENTER button.
Press the Cursor u button to display the count.
5.3. Heat run chacking mode
TOC read the CD, the first song disk search, open / closed later, and again read TOC.
The heat run repetition no. is incremented (increased by 1) when the tray is opened.
Repeat this operation.
[H.R. Chacking] displayed.
Select "H.R.Chacking", and press 1 / 3 ENTER button.
Press the Cursor u button to display the count.
5.4. Error display
Press the Cursor u / i to display the error information.
Heat run error code table
Error Code
E1-00 Disc cannot be detected
E1-01 Tracking offset adjustment not possible
E1-02 Focus offset adjustment not possible
E2-00 Focus servo dropped during playback.
E2-01 Focus servo dropped during searching.
E2-03 Focus servo dropped during TOC reading.
E2-05 Focus servo dropped during manual search.
E2-10 Subcode can no longer be read during playback
E2-11 Subcode can no longer be read during searching
E2-12 Subcode can no longer be read during TOC reading
E2-14 Subcode cannot be read during pause
E2-15 Subcode cannot be read during manual search
E3-00 TOC could not be read within specified time
E3-01 PVD/SVD analysis could not be completed within specified time
E4-04 Search time out (The search was not completed within the stipulated time)
E4-05 Decoder bus error (Error in communications with CD decoder)
E5-00 Inner switch not on
E6-00 Inner switch not off
E8-00 Tray is not opened by the specified time.
E8-01 Tray is not closed by the specified time.
E9-00 CD Microprocessor error
E9-01 Other error
Details of Error code
28