Denon RCD-N7 Service Manual page 45

MEASURING METHOD AND WAVEFORMS
To check the waveforms, the GND (-) probe of the oscilloscope to specified reference voltage.
(Except for lnner SW, TRVSW)
NOTES
Measuring Disc:
(It is better to use wires for extending between the probe and test points.)
• When watching the HF waveform, use the extending wire as short as possible.
• When HF waveform is noisy or cannot discriminate the eye-pattern, replace the Traverse Unit after measuring the lop.
• Point q ～ Q5 is measured with the point shown below.
1. MAIN PCB : TEST POINT
Detail A
A
y
r
u
i
CD/TCD-784
CD-R/TCD-R082W
CD-RW/TCD-W082W
B
w q
t
e
A
Detail B
Q5
Q4
Q3
45
Component side
B