Denon RCD-N7 Service Manual page 38

2. How to update by DPMS
You can update by downloading the latest firmware from the Internet.
2.1. Connecting to the Network
(1) System Requirement
・ Internet Connection by Broadband Circuit
・ Modem
・ Router
・ Ethernet cable (CAT-5 or greater recommended)
(2) Setting
Internet
Router
2.2. Check for Update and Update
Check if the latest firmware exists. You can also check approximately how long it will take to complete an update.
(1) Turn on the power pressing ON/STANDBY button.
(2) Press SOURCE and Cursor u / i buttons. Select the Menu, then press 1 / 3 ENTER button.
・ Press Cursor u / i buttons select to Others. Press 1 / 3 ENTER button.
・ Press Cursor u / i buttons select to Firmware Update. Press 1 / 3 ENTER button.
・ Press Cursor u / i buttons select to CHECK For UPDATE.
(3) Press the 1 / 3 ENTER button.
・ The latest version of the firmware uploaded to the web is displayed.
・ If the latest firmware version is on the web, proceed to (4).
・ If the latest firmware is already installed, press the SOURCE button to close the Update menu.
(4) Press 1 / 3 ENTER button. Select "YES", then press 1 / 3 ENTER button.
(5) Firmware Update will be started.
--- Cautions on Firmware Update ---
・ In order to use these functions, you must have the correct system requirements and settings for a broadband Internet
connection.
・ Do not turn off the power until updating is completed.
Even with a broadband connection to the Internet, approximately about 1 hour is required for the updating procedure
to be completed.
Once updating starts, normal operations on the RCD-N7 cannot be performed until updating is completed.
Also, setting items may be initialized.
Make a note of the settings before updating, and set them again after updating.
Modem
To WAN port
To LAN port
To LAN port
38
Computer
LAN port/
Ethernet
connector
WLAN ANTENNA
NETWORK
ETHERNET SUBWOOFER
PREOUT
connector
RCD-N7W
COAX.
75Ω
ETHERNET
FM
AM
AUX OUT AUX IN 1 AUX IN 2 AUX IN 3