Basic Operations - Clarion DVS9755z Installation Manual

Clarion installation manual
Hide thumbs Also See for DVS9755z:
Table of Contents

Advertisement

7. OPERATION

Basic Operations

CAUTION
Be sure to lower the volume before switch-
ing off the unit power or the ignition key. The
unit remembers its last volume setting. If you
switch the power off with the volume up, when
you switch the power back on, the sudden
loud volume may hurt your hearing and dam-
age the unit.
Turning on/off the power
Note:
• Be careful about using this unit for a long time with-
out running the engine. If you drain the car's bat-
tery too far, you may not be able to start the en-
gine and this can reduce the service life of the
battery.
1. Press the [POWER] button.
2. The settings are displayed on the control unit
display.
3. Press the [POWER] button to turn off the
power.
Switching input source
Change the settings to suit the input signal
source.
• The initial setting is [INTERNAL].
Press the [SOURCE] button.
Each time the [SOURCE] button is pressed, the
indications change as shown below.
[INTERNAL]
[DIGITAL]
[ANALOG2]
[INTERNAL]
• The original mode is resumed when the but-
ton is not pressed during a 7 second inter-
val.
INTERNAL (Internal):
Use this setting for playing back DVD videos and
CDs.
DIGITAL (Digital):
Use this setting when playing back CD changer
media or other digital input sources connected
using an optical-fiber cable.
Note: Be sure to read this chapter referring to the front diagrams of
chapter "4. CONTROLS" on page 5 (unfold).
Use this setting when playing back an analog
input source connected using RCA plugs.
Use this setting when playing back an analog
input source connected using a CeNET cable.
Adjusting the sound volume
The sound volume on a DVD video disc can
become very loud. For that reason, turn up
the sound volume gently when the video
image is displayed.
Press the [VOL] buttons on the control unit.
You can also turn the [VOL] knob on the remote
control unit clockwise or counterclockwise.
[ANALOG1]
Changing display settings
Press the [
Each time the [
pressed, the indications change as shown be-
low.
[PROGRAM]
Displays the sound system used for the DVD
video disc.
ANALOG1 (Analog1):
ANALOG2 (Analog 2):
CAUTION
:increases the sound volume.
:decreases the sound volume
:increases the sound volume.
:decreases the sound volume
] or [
] [DISP] button.
] or [
[SS 1]
[PROGRAM]
PROGRAM (Program):
] [DISP] button are
[SS 2]
[DISP OFF]
11
DVS9755z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents

Save Article as PDF