∗ Check the contents of the enclosed warranty card and keep it carefully with this manual. ∗ The DVH943 can be operated by the CeNET-compatible Clarion Centre Units. These operating instructions note functions which change as the result of connecting the DVH943 to one of the above components.
0.1 channel are recorded discretely, so no crosstalk occurs between channels, and the sense of placement and depth of the sounds is reproduced faithfully. ∗ Manufactured under license from Dolby Laboratories. “Dolby”, “Pro Logic” and double-D symbol are trademarks of Dolby Laboratories. DVH943...
4. CONFIRM BEFORE OPERATION This component does not operate independently as an stand-alone unit and must be used in conjunction with an operational Clarion Source Unit (CeNET supported), or a 5.1 CH surround decoder control unit (DVC923). See section “8. SYSTEM EXPANSION” (P. 14) for details regarding other compatible components.
Page 6
Input Signal Sampling Rate fs=32 kHz fs=44.1 kHz Digital signals fs=48 kHz fs=96 kHz Analog signals (Analog signals: when connected to CeNET connectors or analog input connectors) DVH943 Front speaker Rear speaker (L) Sub-woofer Recording Recording Format channels MP3 etc.
• Larger numbers produce a sharper Q characteristics curve while smaller numbers produce gentler characteristics. Adjustments are made in the range Q1 to Q20. ●GAIN: adjusts the output level. • Adjustments are made in the range -12 dB to +12 dB. DVH943...
Operations (DXZ748RMP) 4. Turn the [ROTARY] knob clockwise or counterclockwise to adjust each value. 5. Press the [ADJ] button to return to the original mode. DVH943 Setting Acoustic Features Turning speakers on or off (SP-SEL) The centre speaker, rear (surround) speakers and sub woofer have to be set to on or off to achieve maximum sound quality.
Page 9
These functions are only available on Dolby Digital DVD discs. 1. Press and hold the [ADJ] button for 1 second or longer to enter adjust mode. 2. Press the [a] or [d] button to change to the [Dolby D] display. DVH943...
• When installing this device or transferring it into another vehicle, for sake of safety, always have this work done by the store of purchase or your nearest Clarion dealer. Installation requires specialized techniques and experience. Setting Auto Volume sensitivity 1.
• The following are enabled only when a control unit is connected. ! Control unit 8P mini DIN plug Connect to control unit. @ Control unit power connector Connect control unit’s power cable here. * Leave tape in place when not in use. DVH943...
[RESET] switch • Following completion of wiring, press the [RESET] switch to return to default settings. DVH943 CAUTION Throughout the process of wiring this unit, disconnect the negative (–) terminal of your automobile’s battery, and leave it disconnected until completely finished.
3. Press the accessory canoe clips from the underside upward through the mat and into the mounting bracket holes. Mounting screws Canoe clips Case 8 mm max. Mounting bracket Case Damage Mounting bracket Mounting screws Floor mat Canoe clips DVH943...
OFF. The centre speaker setting is OFF (default setting is ON). DVH943 Cause Use a narrow stick to press the [RESET] switch on the side of the 5.1ch surround decoder. Note that when the [RESET] switch is pressed, all titles and other data placed in memory will be erased.
Need help?
Do you have a question about the DVH943 and is the answer not in the manual?
Questions and answers