Download
Share
Print this page
Ledj FF-1 User Manual
  1. Manuals
  2. Brands
  3. Ledj Manuals
  4. Controller
  5. FF-1
  6. User manual

Ledj FF-1 User Manual

Hide thumbs
1
2
3
4
5

Advertisement

Quick Links

Download this manual
www.prolight.co.uk
AUTO
BLACKOUT
MODE
SETUP
UP
DOWN
FF-1 Controller
(Order code: LEDJ79)

Advertisement

loading

Related Manuals for Ledj FF-1

Summary of Contents for Ledj FF-1

  • Page 1 AUTO BLACKOUT MODE SETUP DOWN FF-1 Controller (Order code: LEDJ79)

  • Page 3: Operating Determinations

    IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! • Never remove warning or informative labels from the equipment. • Do not open the equipment and do not modify the equipment. • Do not switch the equipment on and off in short intervals, as this will reduce the system’s life. • Only use the equipment indoors. • Do not expose to flammable sources, liquids or gases. • Always disconnect the power from the mains when equipment is not in use or before cleaning! Only handle the power-cable by the plug. Never pull out the plug by pulling the power-cable. • Make sure that the available voltage is between 220v/240v. • Make sure that the power-cable is never crimped or damaged. Check the equipment and the power-cable periodically. • If the equipment is dropped or damaged, disconnect the mains power supply immediately.
  • Page 4 This FF-1 Controller combined with the Funky Floor Panel can make dynamic light shows and can be used for most applications, e.g. stages, discos and night clubs etc. Operations Blackout mode To activate the “BLACKOUT” mode, press the “BLACKOUT” button and the LCD display will start flashing, this means the floor panel is in BLACKOUT MODE (signal output is off). If you press the “BLACKOUT” button again, the LCD display will stop flashing, this now means that you can oper- ate the funky floor panel with the FF-1 Controller. Auto run mode To activate the “AUTO RUN” mode, press the “AUTO” button until the LCD display shows: Now the FF-1 Controller is in the Auto run mode, you can adjust the running times (for each programme) in Auto run mode. Adjust your desired run time by using the “UP” and “DOWN” but-...

  • Page 5: Specifications

    Specifications 6 buttons for easy operation 4 functions: Programme select, Auto run, Sound Active and Blackout mode 16 x 2 LCD display Power supply: DC9-12V, MIN 300mA (by adaptor included) Dimensions: 180 x 132 x 48mm...