Whole Process Of Printing - Procolored A3-R1390 Manual

Note:
If the print head test line is not neat, there are too many missing lines.
Go with F12 "Head Cleaning" again and print again

6.Whole process of printing

6.1 Place the pet film with matte on the
front side
6.3 Make a simple setup and import the
preset parameters
6.5 Set white and color to print
simultaneously. Select "print color
first " and "color+white" , then
press print
6.7 Set the oven at 95-100°c for 200
seconds to cure the powder
6.9 When the heat press transfer is
done , cool the pet film for a few
seconds . then tear the pet film
carefully from the textile and you'
ll get a finished product
11
6.2 Select the image that you want to
print and adjust the size and position
6.4 Open and check the print setting ,
select correct print port .
6.6 When the printing is done , put the
pet film into powder and shake to
make the powder spread evenly
6.8 Set the heat press machine at 160°
c for 40 seconds to start heat
press transfer.
a. lay a piece of shielding paper on the
heat press machine
b. put the textie on the shielding
paper .put the prilnted pet film on the
textile and adjust the position .
c. put the other shielding paper on the
top and set time /temperature
for heat press transfer
*Due to occasional product upgrades, this manual is for reference only.