Machine Installation And Setting - Procolored A3-R1390 Manual

5.Machine Installation And Setting

5.1 Installation of waste ink bottle
a. Unscrew the screws
b. Thread the plastic tube into the waste ink
bottle
c. Fasten the screws
5.3 Put a pet film into the feeder and press
the button of paper shortage to test the
feeder
5.5 Install the pet film tray
5.7 Install the battery to display
P.S.Need to buy an LR44 button battery
5.9 Inject the inks into the ink
cartridges.Use syringes glue syringe
needles and draw out 2-3ml ink from each ink
sarcs respectively.
5.10 Guide the waste ink to the waste ink bin 5.11 Print the test strip
10
5.2 Put one sheet PET film for
testing
P.S. The side with matte of pet film
must put on the front side.
5.4 Set the preheating temperature
between 35°C to 45°C
5.6 Install the pet film reel
5.8 Fill the ink respectively
according to the color instructions
P.S. Try to avoid the outflow of ink
and hold the hard part of ink sac
during Operation
P.S.The test strips need to be clear
and complete
*Due to occasional product upgrades, this manual is for reference only.