Table of Contents
Advertisement
Notes
Always follow the manufacturer's
■
instructions when dosing
all detergents, cleaning aids, care
products and cleaning agents.
Dilute viscous fabric softener
■
and fabric conditioner with water.
This will prevent blockages.
Be careful when opening the
■
detergent drawer while the appliance
is running.
If an individual drying programme is
■
selected, please do not add
detergent and/or care product in the
appliance.
Measuring aid* for liquid detergent
*depending on the model
Position the measuring aid for
measuring the correct amount of liquid
detergent:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer.
Slide the measuring aid forwards,
2.
fold it down and click it into place.
Reinsert the drawer.
3.
Do not use the measuring aid for
Note:
gel detergents and washing powder, or
for programmes with prewash or when
"Finish in" time is selected.
For models without a measuring aid,
pour the liquid detergent into the
appropriate dispenser and place it in
the drum.
Operating the appliance
Starting the programme
Touch the A (Start/Reload) button.
The indicator lamp is lit and the
programme starts.
If you want to secure the
Note:
programme to prevent it from being
adjusted inadvertently, select the
childproof lock.
The display panel shows the Finished in
time while the programme is running or
the programme duration and the
programme progress symbols when the
washing programme has started.
Display panel ~ Page 24
Childproof lock
You can secure the washer dryer to
prevent the set functions from being
changed inadvertently. To do this,
activate the childproof lock when the
programme has started.
Activating/deactivating: Touch and hold
the button 5 (Finish in) for
approx. 5 seconds. The symbol @ is
indicated in the display. If the button
signal is activated, an acoustic signal
sounds.
@ lights up: The childproof lock is
■
activated.
@ flashes: The childproof lock is
■
active and the programme selector
has been adjusted. To prevent the
programme from terminating, reset
the programme selector to the initial
programme. The symbol lights up
again.
Note:
The childproof lock may remain
activated until the next programme
starts, even after the washer dryer has
been switched off. If this is the case,
deactivate the childproof lock before the
programme starts and, if required, re-
activate after the programme starts.
en
31
Advertisement
Table of Contents
