Electrical connection
Electrical safety
:
Warning
Risk of electric shock!
Risk of death if live parts are touched.
When disconnecting the main plug,
■
always pull the plug itself and not the
cable, otherwise the cable could be
damaged.
Never touch or hold the mains plug
■
with wet hands.
Never pull out the mains plug during
■
operation.
Only connect the washer dryer to an
■
alternating current using a correctly
installed earthed socket.
The mains voltage must be the same
■
as the voltage specifications on the
washer dryer (appliance rating
plate).
The connected load and the required
■
fuse are also indicated on the
appliance rating plate.
Ensure that:
The mains plug and socket match.
■
The cable cross-section is adequate.
■
The earthing system has been
■
installed correctly.
A damaged power cord is only
■
replaced by an electrician.
A replacement mains cable can be
obtained from customer service.
You do not use multiple plugs/
■
couplings or extension cables.
If a residual-current-operated circuit
■
breaker is used, you use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
The mains plug is always accessible.
■
The power cord is not kinked,
■
crushed, altered or severed and has
not come into contact with any heat
sources.
Installation and connection
Before washing/drying for the
first time
The washer dryer was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Fluff Clean l programme the first time
without laundry.
Note:
The washer dryer must have been
■
installed and connected properly.
Installation and connection
~ Page 13
Never switch on a damaged washer
■
dryer. Inform your customer service.
~ Page 49
Insert mains plug.
1.
Turn the tap on.
2.
Switch on the appliance.
3.
Close the door. Do not load any
4.
laundry.
Select the Fluff Clean 40°C l
5.
programme.
Open the detergent drawer.
6.
Pour approx. 1 litre of water into
7.
dispenser II.
Add standard detergent to
8.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
9.
Select A (Start/Reload).
10.
When the programme ends, switch
11.
off the appliance.
Your washer dryer is now ready for
use.
en
19