Resetting The Lamp Use Time - JVC DLA-G150 Instructions Manual

Replacing the Light-Source Lamp
I Resetting the Lamp Use Time
After replacing with a new light-source lamp, reset the lamp-time counter inside the projector to clear the accumulated lamp
time to zero (0). After resetting, a new count will start for the new light-source lamp.
I Projector's button
LAMP
4
HIDE
button
KEYSTONE
PRESET
3
EXIT
button
EXIT
Cursor buttons 5/∞
62
STAND BY
indicator
STAND BY
OPERATE
TEMP
OPERATE
indicator
HIDE
1
PC
PC
button
VIDEO
MENU
MENU
button
2
ENTER
button
ENTER
1
Turn on the MAIN POWER switch to go
into stand-by mode.
In stand-by mode, the STAND BY indicator on the
projector lights up.
2
Press the following buttons on the
projector, sequentially.
1 Momentary press the PC button.
2 Momentary press the ENTER button.
3 Momentary press the EXIT button.
4 Press and hold the HIDE button for two seconds
or more.
* During this sequence, the STAND BY and OPERATE
indicators alternately blink about every approx. 3 seconds.
After completion of the sequence, the STAND BY indicator
alone stays on.
* Buttons must be pressed within 2 seconds of the previous
button.
* When you make a mistake in button operations, return to
the beginning of the sequence.
* To check the lamp time on the menu, press the MENU button
and select "Information" with the cursor button 5 or ∞ .
The lamp use time is indicated in the item "Lamp time".
Video main menu
Menu
Image adj.
Input
Setting
Switcher
Color temp.
Source
Options
Language
Lamp time
Information
PC main menu
Menu
Image adj.
Input
Setting
Switcher
Color temp.
Resolution 1280
Frequency H
Options
Frequency V
Language
Lamp time
Information
CAUTION
• Reset the lamp use time only when you have replaced with
a new light-source lamp. Never reset it during lamp life,
otherwise the replacement time may become unclear, and
lead to degraded performance or lamp explosion.
VIDEO
CH.0
NTSC
Lamp time (0 h)
123 h
PC 1
CH.0
1024
79.9 kHz
75 Hz
Lamp time (0 h)
123 h