Water Disposal From The Drip Tray; Replacing The Waterfilter - CASO DESIGN HW 1660 Original Operating Manual

8. Press Start/Stop-button to start the device. The desired water volume will flow out from
water spout. Press Start/Stop-button again, to stop the device. The device will stop
working at once.
9. Alternatively: Press and hold
of baby food. Water with 37°C will be dispensed as long as button is pressed.
10. If you want to dispense water again, repeat the steps above.
► If only a small amount of water is dispensed, then the desired temperature may differ.
Preheat the vessel.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The device has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
14.2.1

Water disposal from the drip tray

1. When the drip tray is full, grasp and stabilize the device by one
hand and use the other hand to lift up the drip tray slightly to
remove it.
2. Lift it slightly to remove it.
3. Remove the water from the drip tray and then hook it back onto
the appliance. Make sure that the drip tray is fixed to the device.
14.2.2

Replacing the waterfilter

1. Remove the water tank lid (A) and remove
the filter holder (B) with the water filter (C).
2. Follow the steps described in Section
"Preparation of the water filter".
-button for dispensing of water with 37°C for preparation
Please note
38