Use; Water Disposal From The Drip Tray; Replacing The Waterfilter - CASO DESIGN HW 400 Original Operating Manual

14.2 Use

1. Fill the watertank with water,
you can remove the watertank
to do this.
2. Place a cup or similar on the
cover of drip tray. Then set the
desired temperature. Switch
the device on, the lamp lights
up in green.
3. The water is heated and flows
into the cup. Switch the device
off, when the desired amount
of water is dispensed.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The ambient temperature changes everyday. This
leads to different amounts of water. It can vary up to +-
15%.
14.2.1

Water disposal from the drip tray

1. When the drip tray is full, grasp and stabilize the
device by one hand and use the other hand to lift up
the drip tray slightly to remove it.
2. Remove the cover of drip tray.
3. Empty the drip tray, replace cover of drip tray, and
insert it into the original place. Make sure it is properly inserted.
14.2.2

Replacing the waterfilter

1. Open the tank cover and take out the box
with the old waterfilter.
2. Soak the new waterfilter upright in water for
10 min.
3. Rinse the new waterfilter thoroughly under
running water.
4. Remove the old waterfilter and replace it
with the new waterfilter (see fig.). Therefor
take out the filter box, place the new
waterfilter and pull it down from the bottom.
1 lid of water tank
2 water tank
3 filter box
4 waterfilter
Please note
31