Perenio PECWS01 Quick Start Manual

Dear Customer, thank you for choosing Perenio® products!
The Door & Window Sensor is sensitive to opening and closing of the door/
window on which it is installed. It is used as part of the Perenio Smart
Building Management System upon detection by the Control Gateway (CG).
BASIC FUNCTIONS AND KEY BENEFITS
For indoor installation only
Battery operated (DC 3V, 125 mAh), 25±5 mm triggering accuracy,
iOS & Android compatibility, support of ZigBee HA 1.2, extended
coverage (connection) area of up to 30 m, ultra-low power consumption,
low battery indication, tool-free installation, compact and stylish design
PACKAGE CONTENTS:
PECWS01 Door & Window Sensor (1 pc.), CR2032 Battery (1 pc.), Screws
with Dowels (1 set), Reset Pin (1 pc.), 3M Mounting tape (2 pcs.), Quick
Start Guide (1 pc.), Warranty Card (1 pc.)
INSTALLATION AND CONFIGURATION
1. Make sure that the Perenio® Control Gateway was pre-installed and
connected to the network through Wi-Fi/Ethernet.
NOTE: The Control Gateway may be purchased as a standalone device or as part of
the Perenio® Smart Kit.
2. Unpack the Door & Window Sensor, open the back cover of the Sensor and
remove the battery insulating strip to power it on. Close the Sensor cover.
Doc Date: March 1, 2018
©Perenio IoT spol., s.r.o. All Rights Reserved
Version: 1.1.0
1