Perenio PECWS01 Quick Start Manual

Dear Customer, thank you for choosing Perenio® products!
The Door & Window Sensor is sensitive to opening and closing of the door/
window on which it is installed. It is used as part of the Perenio Smart
Building Management System upon detection by the Control Gateway (CG).
BASIC FUNCTIONS AND KEY BENEFITS
For indoor installation only
Battery operated (DC 3V, 125 mAh), 25±5 mm triggering accuracy,
iOS & Android smartphone compatibility, support of ZigBee 3.0, extended
connection area of up to 40 m, ultra-low power consumption, low battery
indication, tool-free installation, compact and stylish design.
PACKAGE CONTENTS:
PECWS01 Door & Window Sensor (1 pc.), CR2032 Battery (1 pc.), Screws
with Dowels (1 set), Reset Pin (1 pc.), 3M Mounting tape (2 pcs.), Quick
Start Guide (1 pc.), Warranty Card (1 pc.).
INSTALLATION AND CONFIGURATION
1. Make sure that the Perenio® Control Gateway was pre-installed and
connected to the network through Wi-Fi/Ethernet.
NOTE. The Control Gateway may be purchased as a standalone device or as part of
the Perenio® Smart Kit.
2. Unpack the Door & Window Sensor, open the back cover of the Sensor
and remove the battery insulating film to power it on. Close the Sensor
cover.
Doc Date: November 1, 2018
©Perenio IoT spol s r.o.
Version: 1.4.0
All Rights Reserved
1