Perenio PECMS01 Quick Start Manual

Dear Customer, thank you for choosing Perenio® products!
The Motion Sensor is sensitive to movements of thermal objects in the
area of its installation. It is used as part of the Perenio Smart Building
Management System upon detection by the Control Gateway (CG).
BASIC FUNCTIONS AND KEY BENEFITS
For indoor installation only
Battery operated (DC 3V, 600 mAh), wide detection area (10x6 m at 110°),
PIR Technology of motion detection, day/night mode switch, delay time
switch, iOS & Android compatibility, support of ZigBee HA 1.2, ultra-low
power consumption, low battery indication, compact and stylish design
PACKAGE CONTENTS:
PECMS01 Motion Sensor (1 pc.), CR2045 Battery (1 pc.), Screws with
Dowels (1 set), 3M Mounting tape (1 pc.), Quick Start Guide (1 pc.),
Warranty Card (1 pc.)
INSTALLATION AND CONFIGURATION
1. Make sure that the Perenio® Control Gateway was pre-installed and
connected to the network through Wi-Fi/Ethernet.
NOTE: The Control Gateway may be purchased as a standalone device or as part of
the Perenio® Smart Kit.
2. Unpack the Motion Sensor, open the back cover and remove the
battery insulating strip to power on the device.
Doc Date: March 1, 2018
©Perenio IoT spol., s.r.o. All Rights Reserved
Version: 1.1.0
1