Black & Decker BPT10WTB Instruction Manual page 21

SET UP & USE
DEHUMIDIFY
Ideal for reducing humidity.
• Keep window and door closed for the best dehumidifying effect.
• Exhaust hose attachment is not required to reduce humidity, however it is
recommended in very humid rooms so the warm air can be exhausted outside.
Draining in Dehumidify mode
• It is recommended that the dehumidification drain and drain hose be used for
continuous drainage.
• WATER FULL - When the water level reaches a predetermined level,
indicated on the display. The unit will have to be drained.
NOTE: Refer to Water Drainage section.
• In this mode, fan speed is selected automatically by the appliance and can not
be set manually.
FAN
• Press the Fan Speed Button
HEAT
(HEAT model BPT10HWTB only)
• Select the target temperature 55˚F- 81˚F (13˚C-27˚C) by pressing the
buttons until the desired temperature is displayed on the LED screen.
• Press the Fan Speed Button
NOTE: At the beginning of this mode, you may have to wait a few seconds
before the appliance starts to give out hot air.
• In HEAT mode there will be water removed from the air and collected in the
tank, when the tank is full, the appliance shuts down and "ft" (FULL TANK)
appears on the display, the tank must be Emptied (See water drainage page).
The appliance will start up again.
• When operating in very cold rooms, the appliance defrosts automatically
and may disrupt normal operation. The fan will continue operating for a few
seconds to lower the interior.
• Temperature even after the appliance shuts off. In this mode, the fan may
operate for short periods even though the set temperature has been reached.
to select Low, Medium or High Speed.
to select Low, Medium, High or Auto Speed.
will be
or
Page 21