Black & Decker BPT10WTB Instruction Manual page 16

SET UP & USE
COOL MODE
Ideal for hot weather when
you need to cool the room.
To set operation of the
appliance correctly, press
the or buttons until the desired
temperature is displayed. (See Fig. 7)
Then select the fan speed by pressing
the Fan Speed Button until the light
corresponding to the required fan
speed lights up:
HIGH: The Fan operates at
maximum to reach the
required temperature as
rapidly as possible.
MED: Reduces Fan noise level but
still maintains cooling.
LOW: For quiet operation.
AUTO: The appliance automatically
selects the most suitable
fan speed in relation to the
temperature set on the
digital display.
DEHUMIDIFY MODE
Ideal for reducing humidity in
spring and autumn, during
rainy spells or in damp rooms,
etc.
• Keep window and door closed for
the best dehumidifying effect.
• Exhaust hose attachment is not
required to reduce humidity,
however it is recommended in very
humid rooms so the warm air can be
exhausted outside.
DRAINING IN
DEHUMIDIFICATION MODE
• It is recommended that the
dehumidification drain and drain
hose can be used for continuous
drainage.
• WATER FULL - When the water level
reaches a predetermined level,
will be indicated on the display. The
unit will have to be drained.
Page 16
NOTE: Refer to Water Drainage
FAN MODE
Adjust fan speed by pressing
the Fan Speed button as
described for the cool mode.
In this mode, AUTO fan cannot be
selected.
The fan speed selected will show in the
display. One row for Low, Two rows
for medium and three rows for high.
(See fig. 9)
HEAT MODE
(HEAT MODEL BPT10HWTB ONLY)
Press the MODE button until the HEAT
mode indicator light appears. Select
the target temperature by pressing
the or button until the corresponding
value is displayed. (Temperature range
is 55˚to 81˚F).
Select the fan speed by pressing
the Fan Speed Button until the light
corresponding to the desired fan
speed lights up: HIGH, MED, LOW,
AUTO.
Fig. 8
NOTE: At the beginning of this mode,
In HEAT mode there will be water
removed from the air and collected
in the tank, when the tank is full, the
appliance shuts down and "ft" (FULL
TANK) appears on the display, the
tank must be emptied (See water
drainage page). The appliance will
start up again.
Then operating in very cold rooms,
the appliance defrosts automatically
and may disrupt normal operation.
The fan will continue operating for
a few seconds to lower the interior
temperature even after the appliance
shuts off. In this mode, the fan may
operate for short periods even though
the set temperature has been reached.
section.
you may have to wait a few
seconds before the appliance
starts to produce hot air.
Fig. 9