Black & Decker BPT10WTB Instruction Manual page 24

SET UP & USE
FOLLOW ME
Parts of the room are cooler where there is a draft. Other parts are warmer due
to direct sunlight. The FOLLOW ME Function allows the room to be cooled
according to the room temperature, wherever the remote is located.
• This function can be activated from the remote control ONLY. The remote
control serves as a thermostat allowing for the precise temperature control at
its location.
• To activate the Follow Me function, point the remote control towards the
appliance and press the FUNCTION
• Press either the
the LED screen.
• Press the Menu
on the LED screen.
• The remote will display the actual temperature at its location. The remote
control will send this signal to the air conditioner at 20 minute intervals.
• If the unit does not receive the Follow Me/Temp Sensing signal during a 25
minutes interval, the follow me function will be canceled and will need to be
reactivated.
NOTE: · The remote must be within 23 feet of the remote control receiver on the
air conditioner unit. It should not have any obstructions.
• To cancel this function, press the
until the flashes onscreen, and then press the
cancellation. The
TIMER BUTTON
• The timer can be used to delay the appliance start-up or shutdown.
PROGRAMMING START-UP
• With the appliance ON select the settings that you would like to program
at start-up. Example: COOL Mode, temperature, fan speed. Turn OFF the air
conditioner.
• Press the button twice, the LED screen will display hours, the
symbol will flash
• Press the or
switch on using the buttons (from 30 minutes to 24 hours).
• During the first ten hours you can select half hour intervals. For times longer
than ten hours, one hour intervals can be selected.
• Press the button again to activate the selected time. The
will be displayed on the LED screen
on the LED screen
Page 24
OR button until the FOLLOW ME
button. The FOLLOW ME
will stop flashing and disappear from the screen.
.
button to set the time when you want the appliance to
button.
will stop flashing and illuminate
, then press either the
button to confirm the
. Remaining time will be displayed
symbol flashes on
or button
symbol and
symbol and