Table of Contents
Advertisement
Care and maintenance
EN
operate it if you find broken and worn parts.
General Cleaning
1. Clean the product with a damp cloth and pH-neutral soap. Use a brush for
areas that are hard to reach.
2. In particular clean the air vents (21) after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
4. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using
the product again.
Sprocket wheel
1. Clean the sprocket wheel (12a).
2. Using a disposable lube gun, insert the needle nose into the lubrication
hole (12b) (Fig. 38) and inject grease until it appears at the outside edge of
the sprocket wheel (12a).
3.
4. Rotate the saw chain (11) by hand. Repeat the lubrication procedure until
the entire sprocket wheel (12a) has been greased.
42
WARNING! Only perform repairs and maintenance work according
to these instructions! All further works must be performed by a
qualified specialist!
NOTE: Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
NOTE: It is not necessary to remove the saw chain (11) to lubricate
the sprocket wheel (12a). Lubrication can be done on the job.
11
12
12a
12b
Fig. 38
TTI932CHN
Advertisement
Table of Contents
