Transport - Positioning On Site; Dimensions And Weight; Installation - Uniflair RAN Series Instruction Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

The dry cooler leaves the factory in perfect condition, at the moment of delivery its condition should be carefully

checked and any damage which might have been caused in transit should be notified in writing to the haulier.

During transit and positioning on site:

• Do not overturn or lean the dry cooler on its side.

Before removing the packaging carry the dry cooler to the nearest possible point to the actual installation

•

location by using a pallet truck or a forklift securing the unit to ensure that it does not fall off.

remove all packing with care, make sure that the unit is not damaged in any way.

•

The symbols shown on the unit packaging conform to ISO7000 standards. Their meaning is explained in the

table below.

SYMBOL

MEANING

FRAGILE: handle with care.

PROTECT AGAINST MOISTURE:

the packed unit must be stored in

a dry place.

CENTRE OF GRAVITY: shows the

centre of gravity of the packed

unit.

KEEP AWAY FROM HEAT: the

unit must be kept away from heat

sources.

See drawing DIUI ........... attached.

Position the dry cooler in the open air out of direct sunlight.

It can be installed:

• with horizontal air discharge for best protection (from snow or from objects falling from above) and easier

maintenance; in this configuration the dry cooler must be protected from the wind which could interfere with

the operation of the fan;

• with vertical air discharge ; this configuration is recommended for installation in windy locations or where a

horizontal air flow would be easily obstructed, available with optional leg kit Leg kit includes assembly

instructions.

Position the dry cooler on a solid, level surface.

Fix the dry cooler down using the appropriate bolt holes in the base (horizontal air discharge) or in the bottoms

of the legs (vertical air discharge)

RAN-RAL - Rev 1.0. - 11-10-2002 IT - EN