Brocade Communications Systems VDX6720 Hardware Reference Manual page 50

5
Replacing a fan assembly in the VDX 6720/6730-60
1. Using the Phillips screwdriver, unscrew the captive screw on the fan assembly.
2. Remove the fan assembly from the chassis by pulling the handle on the fan assembly out and
3. Install the new fan assembly in the chassis:
CAUTION
Do not force the installation. If the fan assembly does not slide in easily, ensure that it is correctly
oriented before continuing.
FIGURE 16
4. Verify that the fan status LED is steady green to indicate normal operation (see
38
away from the chassis.
a. Orient the new fan assembly with the captive screw on the right, as shown in
b. Gently push the fan assembly into the chassis until it is firmly seated.
c. Using the Phillips-head screwdriver, secure the fan assembly to the chassis by tightening
the captive screw.
Inserting the fan assembly in the Brocade VDX 6720/6730-60
You can also enter one of the following commands at the command line prompt to display fan
status.
•
show chassis
•
show environment fan
Brocade VDX 6720/6730 Hardware Reference Manual
Figure 16.
Table 7).
53-1002084-01