Brocade Communications Systems VDX6720 Hardware Reference Manual page 47

3. Using the Phillips screwdriver, unscrew the two captive screws on the power supply.
4. Remove the power supply from the chassis by pulling the handle on the power supply out and
5. Install the new power supply in the chassis:
CAUTION
Do not force the installation. If the power supply does not slide in easily, ensure that the power
supply is correctly oriented before continuing.
FIGURE 14
6. Plug the power cord into the power supply to power on the unit.
7.
Brocade VDX 6720/6730 Hardware Reference Manual
53-1002084-01
away from the chassis.
a. Orient the power supply with the staus LED on the left, as shown in
b. Gently push the power supply into the chassis until it is firmly seated.
c. Secure the power supply to the chassis by tightening the two captive screws using the
Phillips screwdriver.
Inserting the power supply in the Brocade VDX 6720/6730-60
The power supply will immediately attempt to power up.
Verify that the LED on the new power supply displays steady green while the Brocade VDX
6720/6730-60 is operating (see
supply is securely installed and seated properly.
Replacing a power supply FRU in a VDX 6720-60
Table 6). If the LED is not steady green, ensure that the power
5
Figure 14.
35