Table of Contents
Advertisement
4.3.5 Configuration (continued)
I) Start Recording - Recording Settings
Type: The selections are: "No Recording", "Limited", and "Full Flash".
No Recording: Not used.
Limited: You must define the Start Date and Time, and End Date and Time in which
you need the recording to be done.
Full Flash: You only need to define the Start Date and Time. The iServer will record
data until the Flash is full, then the iServer will stop recording.
Interval: The recording interval at which the temperature or humidity is being stored
into the Flash Card. The selections are "10 seconds" and "1 minute".
To avoid any miscommunications when downloading the stored data using the
iFlash program or from the "Chart" page, it is strongly recommended to let the
recording run for a minimum of 3 minutes if the time interval is 10 seconds (from
the "Configuration" page), and 15 minutes if the time interval is 1 minute.
Clock Date and Time: Real Time Clock, carried over from Configuration Page, you
may update it here as needed.
Start Date, Time: Starting date and time for recording. Entry is required for Limited and
Full Flash types of Recording.
End Date, Time: Ending date and time for recording. Entry is required for Limited
type of Recording only.
The Date and Time formats are mm/dd/yyyy and hh:mm:ss. Time is military time /
24 hour based. The exact formats are required otherwise an Entries Error
message will appear in Section C.
J) Read Settings: Click this button, followed by clicking the "Update" button, to retrieve
the latest Recording Settings.
Hard Reset: Clicking on this button will reset the Ethernet Port, Flash Card Memory,
LCD, and Recording sections to a fresh start. It is suggested to click "Hard Reset" if
you experience problems with the "Start Recording" button.
If the unit is recording, the "Hard Reset" button will not function.
Figure 4.12 Configuration - Recording Settings
28
Advertisement
Table of Contents
