Checking The Battery Charge Level; Changing/Inserting The Tool/Collet Chuck; Switching On And Off/Setting Speed Range - Parkside PFBS 12 B6 Translation Of The Original Instructions

Stop charging
♦ Disconnect the USB mains adapter from the mains power supply.
♦ Disconnect the USB charging cable
CAUTION!
► Never recharge a battery again immediately after charging. There is a risk that the
battery will become overcharged.

Checking the battery charge level

If the appliance is switched on, the remaining charge will be shown on the battery LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Changing/inserting the tool/collet chuck

♦ Press the spindle lock
♦ Turn the tensioning nut
♦ Undo the tensioning nut
♦ Remove any attached tool.
♦ First push the intended tool through the tensioning nut
appropriate collet chuck
♦ Press the spindle lock
♦ Push the collet chuck
the combination spanner
NOTE
► Use the screwdriver side of the combination spanner
screw on the mandrel
Switching on and off/setting speed range
Switching on/setting the speed range
♦ Set the On/Off switch
♦ Set the speed control
Switching off
♦ Set the On/Off swtch
│ GB │ IE
■ 12
from the charging socket
and hold it down.
until the lock clicks into place.
from the thread using the combination spanner
for the tool shaft.
and hold it down.
into the thread insert and screw the tensioning nut
.
.
to the position "I".
to a position between "1" and "MAX".
to the position "O".
on the appliance.
before inserting it into the
to undo and tighten the
PFBS 12 B6
.
tight with