Sealey LED0121B Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to
instructions
1. safety
8
do not shine directly into your, another person's or an animal's eyes.
8
do not allow children to use the torch.
8
do not use the torch if you suspect that the battery or the torch casing is damaged.
8
do not leave batteries in torch for long periods of inactivity.
8
do not attempt to open, disassemble, modify or service the battery.
do not crush, puncture, short external contacts or dispose of in fire or water.
8
9
replace only with the battery designated for this product.
9
recycle or dispose of used battery as stipulated by local regulation.
9
if the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. if it gets in your eyes, rinse thoroughly with cool
water and seek immediate medical attention.
2. introduction
innovative two in one interchangeable worklight with quick release function. includes 250 lumen torch with sliding focus, and a slimline 350
lumen coB inspection lamp with 180° tilt function and an additional led directional torch. features a power indicator on the switch and a
magnet on the base for hands free operation. supplied in a presentation box. can be used with attachment led0121f (flexible inspection
lamp).
3. specification
model no ...............................................................led0121r
Battery ........................................................3.7V 2.2Ah li-ion
Power ................................................................................5W
lumen output ....................... inspection:350lm, torch: 250lm
operating time ..............................................................2.5hr
charging time ...................................................................4hr
4. operation
Operation (fig.2)
4.1.
4.1.1. Attach one of the interchangeable work lights by pushing into the main body, this will release the red sleeve and lock in place.
4.1.2. to remove the work light, slide the red sleeve in the direction of the arrow this will allow the work light to be removed
4.1.3. to turn on press the on/off button, once for brightest, again for low light and once more to turn off.
4.1.4. the torch has a sliding focus.
4.1.5. the lamp can be tilted through 180°. the button switch, switches off the lamp and switches on the directional lamp positioned on the
end of lamp.
4.1.6. the flexible inspection lamp (led0121f not supplied) has adjustable focus and 350mm flexible neck for use in areas where access is
limited.
4.1.7. the torch has a magnetic base for hands free use.
4.2. battery installation/removal
4.2.1. unscrew end cap on main body of torch. (fig.1)
4.2.2. slide the battery holder out of the body of the torch.
4.2.3. remove/insert 3 x AAA batteries into holder.
4.2.4. slide battery holder back into body of torch.
4.2.5. screw end cap back onto body of torch.
5. maintenance
5.1. Keep lamp clean and check for damage before every use. if damage is observed, remove from use until unit is repaired.
© Jack sealey limited
instructions for
cob led interchangeable inspection
lamp & torch 3 x aaa
led0121b
model no:
Original Language Version led0121B | issue 1 19/05/17