Sealey LED032 Instruction Manual

thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL
 WARNING! Disconnect lamp from power before performing any maintenance.
 DO NOT shine lamp directly into your, other person's or animal's eyes.
 DO NOT allow children to use the lamp.
 Maintain the lamp in good condition.
 DO NOT use the lamp if the lamp if damaged.
 When not in use store the light in a safe, dry, childproof location.
 WARNING! Ensure Health and safety, local authority and general workshop practice regulations are adhered
to when using this light.
Wear approved eye protection. A full range of safety equipment is available from your sealey dealer.
Wear suitable clothing to avoid snagging.
DO NOT wear jewellery and tie back long hair.
Account for all tools being used and DO NOT leave them in or near the engine.
 WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all
possible conditions and situations that may occur. It must be understood that common sense and caution
are factors which must be applied by the operator.
2. INTRODUCTION
robust design with built-in spring loaded telescopic mounting brackets. soft padded hooks provide good protection
against bonnet. 30 sMD LEDs give complete engine bay illumination. supplied with 5mtr cable and battery terminal
clips.
Model No: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LED032.
Voltage: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12V.
Power: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7W.
Lamp Type: . . . . . . . . . . . . . . . . . . . . . . 30 x 3528 sMD.
Minimum/ Maximum Bonnet Width . . . 1230/1940mm.
© Jack sealey Limited
InstructIon MAnuAL for:
UNDER BONNET LAMP 30 SMD 12V
MODEL NO: LED032
Original Language Version
LED032 Issue: 1 - 29/01/13